Bucket Elevator

Product Introduction

The machine is mainly applied for vertical elevating of power or granule materials. Multi buckets are installed on a circulation chain or belt. When working, the materials will be loaded into bucket from the bottom and then discharged when bucket moves to top. The buckets work continuously in circulation in a closed shell to realize continuous materials elevating. The machine is characterized in large elevating capacity, low energy consumption, low noise, good seal performance, no dust leakage, safe and reliable.

【Elevating Height】:≤50m

【Conveying Capacity】:5~100 t /h

【Application Industry】:Suitable for materials in industries such as food, medicine, chemical, agricultural chemicals, building materials, plastics, coatings, mining industry, dye, metallurgy, cement mortar etc etc.. (For more application industry, please click “Free Consultation”)

【Applicable Materials】:Applicable for powders such as cement, titanium white, dry mortar, pesticides, putty powder, calcium carbonate, polyethylene, polypropylene, clay, bentonite, thickening etc.

Product Advantages

High efficiency
Driving power is small.  Use in-flow type feeding, induction type discharging, hoppers with large loading capacity are intensively layout. so it has high energy efficiency because it is almost no materials go back or materials dug phenomenon.
Wide Application range
Wide range of application. This kind of elevator does not have many requirements of materials variety, materials property etc. It not only can elevate materials like general powders, granules, it is also can elevate materials with strong wearness. It has nice sealing and less environmental pollution.
Stable operation, low failure rate
Good reliability, advanced design principle and processing method ensure the reliability of the machine running. None failure time is more than 20000 hours. It runs stably so it is also suitable for lifting materials to higher places.
Long service life
Service life is long. The elevator feeding way is inflow type and no need to get the materials with the bucket. Little extrusion and collision among the parts. The machine is designed to ensure that material during feeding and discharging will be scattered little, which reduce the mechanical wear.

Working Principle

The recycling bucket of Bucket Elevator scoops the materials up from the storage bin, elevate to the top with the conveyor belt or chain, flip down after bypass the top wheel, and poured material into the receiving groove. Belt driving (The belt normally is rubber belt) of Bucket Elevator is installed at top and down transmission drum or the top and down idler drum . Chain driving (generally are two parallel transmission chain) is installed on the Bucket Elevator, at the top and down, there are a pair of drive sprocket. At down and top, there is a pair of idler sprocket. Normally the bucket elevator is with shell to prevent the dust inside the bucket and also dust generated during delivery.

Typical Case

Becket Elevator handover
The customer is a famous building materials manufacturers and located in Huzhou, Zhejiang. The attachment is the elevating site of mortar production line provided by Siehe Industry.

【Model】:STDT
【Elevating Height】:13m/20m
【Product Features】:The conveying capacity is about 20m³/h

Technical Parameter

   * The capacity is data based on powder with specific gravity 1g/cm3. The model selection shall be based on the data such as the materials mesh, specific gravity etc..
   * Special operation condition, such as high temperature, high pressure, explosive, combustible and corrosive etc, details are required for correct model selection.  
   * If any change in the above table, subject shall prevail without notice.
   * The table cannot include all products, please contact with our sales engineers for more information.